The control module detected improper operation of the Injector 6 circuit. This is the manufacturer-specific definition used by Chevrolet.
Causes possibles
- Wiring
- injector
- ECM
Base de données DTC TuningBot · v4.41.2
11 interprétations spécifiques au constructeur chez 10 constructeurs dans la base DTC TuningBot.
The control module detected improper operation of the Injector 6 circuit. This is the manufacturer-specific definition used by Chevrolet.
The control module detected that the Engine oil temperature (EOT) - temperature value was below the expected limit. This is the manufacturer-specific definition used by Chrysler.
The control module detected that the Engine oil temperature (EOT) - temperature value was below the expected limit. This is the manufacturer-specific definition used by Dodge.
The control module registered the fault condition described as "Speed Fuel Pump Positive Feed Fault". This is the manufacturer-specific definition used by Ford.
The control module detected that the Engine Oil Temperature value was below the expected limit. This is the manufacturer-specific definition used by Jeep.
The control module detected a fault associated with the Speed Fuel Pump Positive Feed circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Mazda.
The control module judged the Crankshaft position (CKP) behaviour implausible for the current operating conditions. This is the manufacturer-specific definition used by Mitsubishi.
The control module judged the Throttle position (TP) behaviour implausible for the current operating conditions. This is the manufacturer-specific definition used by Nissan.
The control module detected a fault associated with the Fuel Injector Cylinder 3 circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Porsche.
The control module detected an interruption (open circuit) in the Injector 3 circuit, so the expected electrical continuity was not present. This is the manufacturer-specific definition used by Audi.
The control module detected an interruption (open circuit) in the Fuel Injector for Cylinder 3 (N32) circuit, so the expected electrical continuity was not present. This is the manufacturer-specific definition used by Volkswagen. Volkswagen Group tools also report it as fault code 17647. Documented across Volkswagen Group applications (Audi, SEAT and Škoda included).
Groupe motopropulseur : moteur, boîte et transmission.
Plage définie par le constructeur : la signification peut varier selon les marques.
Index de défaut spécifique dans le sous-système.
Code défaut de diagnostic (11 interprétations). The control module detected improper operation of the Injector 6 circuit. This is the manufacturer-specific definition used by Chevrolet.
P1239 est un code spécifique au constructeur. Dans cette base il est documenté pour : Chevrolet, Chrysler, Dodge, Ford, Jeep, Mazda, Mitsubishi, Nissan, Porsche, VAG. Le même numéro peut signifier autre chose sur d'autres marques.
Si la logique du défaut réside dans la calibration de l'ECU, oui : notre service DTC Removal désactive l'entrée de défaut concernée. La correction du checksum n'est pas incluse : c'est un service à part, en option. Vous ne savez pas si votre cas est concerné ? Demandez une évaluation gratuite et nos ingénieurs examineront votre fichier.
Comprendre le système derrière ce code : Stratégie de diagnostic et logique DTC