P1154 Code défaut de diagnostic (9 interprétations)

The control module detected that the Fuel Rail Pressure Malfunction Rail Pressure Is value was below the expected limit. This is the manufacturer-specific definition used by Dodge.

The control module detected a fault associated with the Bank 2 Fuel Control Shifted Rich circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Ford.

The control module detected a fault associated with the Heated oxygen sensor (HO2S) - LH front - slow operation circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Honda.

The control module detected that the Fuel Rail Pressure Malfunction Rail Pressure Is value was below the expected limit. This is the manufacturer-specific definition used by Jeep.

The control module detected improper operation of the Heated oxygen sensor (HO2S) - front, bank 2. This is the manufacturer-specific definition used by Kia.

The control module detected a short circuit to ground in the Motorised throttle control circuit. Documented for the Magneti Marelli MM6KP engine ECU (EW7A/EW10A) on Peugeot applications; the same PSA control units are also fitted to Citroën models.

The control module judged the Heated oxygen sensor (HO2S) 1, bank 2 behaviour implausible for the current operating conditions. This is the manufacturer-specific definition used by Subaru.

The control module detected improper operation of the Manifold Switch Over. This is the manufacturer-specific definition used by Audi.

The control module detected improper operation of the Manifold Switch Over. This is the manufacturer-specific definition used by Volkswagen.