The control module detected that the signal in the Fuel Injection Control Module circuit stayed below the expected operating range. This is the manufacturer-specific definition used by Ford.
Mögliche Ursachen
- Fuse
- wiring
- FICM relay
TuningBot DTC-Datenbank · v4.37.15
5 herstellerspezifische Interpretationen bei 3 Herstellern in der TuningBot DTC-Datenbank.
The control module detected that the signal in the Fuel Injection Control Module circuit stayed below the expected operating range. This is the manufacturer-specific definition used by Ford.
The control module detected the fault condition "Rate below the major polluter threshold" for the Combustion misfiring. Documented for the Bosch MED 17.4.x engine ECU (EP6 THP family) on Peugeot applications; the same PSA control units are also fitted to Citroën models.
The stored code identifies a fault of the Detection of misfires. Documented for the Bosch MEV17.4 engine ECU (EP6 1.6 VTi) on Peugeot applications; the same PSA control units are also fitted to Citroën models. PSA documentation does not characterise the failure mode further.
The control module detected a short circuit to ground in the Ignition coil/amplifier, cylinder 8 circuit. This is the manufacturer-specific definition used by Audi.
The control module detected a short circuit to ground in the Cylinder 8 Ignition circuit. This is the manufacturer-specific definition used by Volkswagen.
Antriebsstrang: Motor, Getriebe und Antrieb.
Herstellerdefinierter Bereich: die Bedeutung kann je Marke abweichen.
Spezifischer Fehlerindex innerhalb des Subsystems.
Diagnose-Fehlercode (5 Interpretationen). The control module detected that the signal in the Fuel Injection Control Module circuit stayed below the expected operating range. This is the manufacturer-specific definition used by Ford.
P1378 ist ein herstellerspezifischer Code. In dieser Datenbank ist er dokumentiert für: Ford, PSA, VAG. Dieselbe Nummer kann bei anderen Marken etwas anderes bedeuten.
Wenn die Fehlerlogik in der Steuergerätekalibrierung liegt, ja: unser DTC-Removal-Dienst deaktiviert den konkreten Fehlereintrag. Die Checksum-Korrektur ist nicht enthalten: Sie ist ein separater, optionaler Service. Unsicher, ob Ihr Fall dazugehört? Fordern Sie eine kostenlose Einschätzung an, und unsere Ingenieure prüfen Ihre Datei.
Das System hinter diesem Code verstehen: Diagnosestrategie und DTC-Logik