The control module detected that the signal in the Fuel Injection Control Module circuit stayed below the expected operating range. This is the manufacturer-specific definition used by Ford.
Causas possíveis
- Fuse
- wiring
- FICM relay
Base de dados DTC TuningBot · v4.37.15
5 interpretações específicas do fabricante em 3 fabricantes na base de dados DTC TuningBot.
The control module detected that the signal in the Fuel Injection Control Module circuit stayed below the expected operating range. This is the manufacturer-specific definition used by Ford.
The control module detected the fault condition "Rate below the major polluter threshold" for the Combustion misfiring. Documented for the Bosch MED 17.4.x engine ECU (EP6 THP family) on Peugeot applications; the same PSA control units are also fitted to Citroën models.
The stored code identifies a fault of the Detection of misfires. Documented for the Bosch MEV17.4 engine ECU (EP6 1.6 VTi) on Peugeot applications; the same PSA control units are also fitted to Citroën models. PSA documentation does not characterise the failure mode further.
The control module detected a short circuit to ground in the Ignition coil/amplifier, cylinder 8 circuit. This is the manufacturer-specific definition used by Audi.
The control module detected a short circuit to ground in the Cylinder 8 Ignition circuit. This is the manufacturer-specific definition used by Volkswagen.
Motor e transmissão: motor, caixa e transmissão.
Intervalo definido pelo fabricante: o significado pode variar entre marcas.
Índice específico da avaria dentro do subsistema.
Código de avaria de diagnóstico (5 interpretações). The control module detected that the signal in the Fuel Injection Control Module circuit stayed below the expected operating range. This is the manufacturer-specific definition used by Ford.
P1378 é um código específico do fabricante. Nesta base de dados está documentado para: Ford, PSA, VAG. O mesmo número pode significar outra coisa noutras marcas.
Se a lógica da avaria vive na calibração da ECU, sim: o nosso serviço DTC Removal desativa a entrada de avaria específica. A correção do checksum não está incluída: é um serviço à parte e opcional. Não sabe se o seu caso se aplica? Peça uma avaliação gratuita e os nossos engenheiros verificam o seu ficheiro.
Entenda o sistema por trás deste código: Estratégia de diagnóstico e lógica DTC