P1000 Code défaut de diagnostic (9 interprétations)

The control module detected a fault associated with the VVT control circuit, solenoid loss, bank 1 circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by BMW.

The control module judged the Ignition coil, 5 - primary signal implausible: it stayed inside electrical limits but did not match the value expected for the current operating conditions. This is the manufacturer-specific definition used by Dodge.

The control module detected a fault associated with the On Board Diagnostic System Readiness Test Not Complete circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Ford.

The control module detected a fault associated with the System diagnosis incomplete circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Kia.

The control module detected a fault associated with the Engine control module (ECM) memory erased - no codes stored circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Land Rover.

The control module detected a fault associated with the OBD - 11 monitor testing not complete circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Mazda.

The control module's internal test reported the Transmission shift lever control module as faulty. This is the manufacturer-specific definition used by Mercedes-Benz.

The control module detected a fault associated with the Secondary AIR Delivery circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by MINI.

The control module detected improper operation of the Engine control module (ECM) circuit. This is the manufacturer-specific definition used by Volvo.