P1462 Diagnose-Fehlercode (12 Interpretationen)

The control module detected that the signal in the Fuel Level Output circuit stayed below the expected operating range. This is the manufacturer-specific definition used by Chrysler.

The control module judged the Engine coolant temperature (ECT) signal implausible when compared with other operating data. This is the manufacturer-specific definition used by Dodge.

The control module detected that the signal in the Air Conditioning Pressure circuit stayed below the expected operating range. This is the manufacturer-specific definition used by Ford.

The control module detected that the AJC refrigerant pressure signal stayed above the expected range. This is the manufacturer-specific definition used by Land Rover.

The control module detected a fault associated with the A!C refrigerant pressure sensor - low voltage circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Mazda.

The control module registered the fault condition described as "Heated Catalyst Internal Control Module Checksum/ROM Error". This is the manufacturer-specific definition used by MINI.

The control module detected an internal control-unit fault (Difference between the stops programmed at short term). Documented for the Bosch EDC16C34 injection ECU (DV6TED4 1.6 HDi) on Peugeot applications; the same PSA control units are also fitted to Citroën models.

The control module detected an internal control-unit fault (Programming of the electric EGR valve; Discrepancy in the programming of the top stop ( valve open)). Documented for the Delphi DCM 3.5 injection ECU (DW10C 2.0 HDi) on Peugeot applications; the same PSA control units are also fitted to Citroën models.

The control module detected the fault condition "Locked open" for the EGR valve initialisation. Documented for the Magneti Marelli MM6KP engine ECU (EW7A/EW10A) on Peugeot applications; the same PSA control units are also fitted to Citroën models.

The control module detected an internal control-unit fault (Difference between the stops programmed at short term). Documented for the Siemens SID 803 injection ECU (DW10BTED4 2.0 HDi) on Peugeot applications; the same PSA control units are also fitted to Citroën models.

The control module judged the Exhaust gas recirculation temperature (EGRT) control, Bank 2 behaviour implausible for the current operating conditions. This is the manufacturer-specific definition used by Audi.

The control module judged the Exhaust gas recirculation temperature (EGRT) control behaviour implausible for the current operating conditions. This is the manufacturer-specific definition used by Volkswagen.