The control module detected that the Engine oil temperature (EOT) voltage stayed below the expected range. This is the manufacturer-specific definition used by Chevrolet.
Mögliche Ursachen
- Wiring open circuit/short circuit to ground
- EOT sensor
- ECM
TuningBot DTC-Datenbank · v4.37.15
11 herstellerspezifische Interpretationen bei 11 Herstellern in der TuningBot DTC-Datenbank.
The control module detected that the Engine oil temperature (EOT) voltage stayed below the expected range. This is the manufacturer-specific definition used by Chevrolet.
The control module detected improper operation of the Fuel rail pressure (FRP). This is the manufacturer-specific definition used by Dodge.
The control module detected a fault associated with the Variant Selection circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Ford.
The control module detected that the Fuel tank temperature signal stayed below the expected range. This is the manufacturer-specific definition used by Honda.
The control module registered the fault condition described as "Fuel Pressure Monitoring - Regulator Valve Stuck". This is the manufacturer-specific definition used by Hyundai.
The control module detected a fault associated with the Throttle Inlet Pressure/MAP Correlation circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Jeep.
The control module detected a fault associated with the Fuel Pressure Monitoring - Regulator Valve Stick circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Kia.
The control module detected improper operation of the Oxygen sensor heater 1 - cylinders 1, 2, 3, 4, 5, 6 circuit. This is the manufacturer-specific definition used by Land Rover.
The control module detected a fault associated with the O2 Sensor Heater Control Circuit Bank 2 Sensor 2 circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by MINI.
The control module detected improper operation of the Heated oxygen sensor (HO2S) 1, Bank 1 or 2 circuit. This is the manufacturer-specific definition used by Audi.
The control module detected that the air-fuel mixture stayed leaner than the target despite full corrective control (System). This is the manufacturer-specific definition used by Volvo.
Antriebsstrang: Motor, Getriebe und Antrieb.
Herstellerdefinierter Bereich: die Bedeutung kann je Marke abweichen.
Spezifischer Fehlerindex innerhalb des Subsystems.
Diagnose-Fehlercode (11 Interpretationen). The control module detected that the Engine oil temperature (EOT) voltage stayed below the expected range. This is the manufacturer-specific definition used by Chevrolet.
P1187 ist ein herstellerspezifischer Code. In dieser Datenbank ist er dokumentiert für: Chevrolet, Dodge, Ford, Honda, Hyundai, Jeep, Kia, Land Rover, MINI, VAG, Volvo. Dieselbe Nummer kann bei anderen Marken etwas anderes bedeuten.
Wenn die Fehlerlogik in der Steuergerätekalibrierung liegt, ja: unser DTC-Removal-Dienst deaktiviert den konkreten Fehlereintrag. Die Checksum-Korrektur ist nicht enthalten: Sie ist ein separater, optionaler Service. Unsicher, ob Ihr Fall dazugehört? Fordern Sie eine kostenlose Einschätzung an, und unsere Ingenieure prüfen Ihre Datei.
Das System hinter diesem Code verstehen: Lambdasonden