P1635 Code défaut de diagnostic (8 interprétations)

The control module detected a fault associated with the PCM Memory Performance or Write circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Dodge.

The control module detected a fault associated with the Tire / Axle Ratio Out of Acceptable Range circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Ford.

The control module detected improper operation of the Battery condition monitor module. This is the manufacturer-specific definition used by Honda.

The control module detected improper operation of the Water Heater Relay. This is the manufacturer-specific definition used by Hyundai.

The control module registered the fault condition described as "Engine control module (ECM) - processor fault". This is the manufacturer-specific definition used by Mazda.

The control module's internal test reported the Engine control module (ECM) as faulty. This is the manufacturer-specific definition used by Opel.

The control module did not receive the expected CAN data bus, AC signal. This is the manufacturer-specific definition used by Audi.

The control module detected that the Engine control module (ECM), internal temperature signal stayed below the expected range. This is the manufacturer-specific definition used by Volvo.