TuningBot DTC Database · v4.37.14
7 manufacturer-specific interpretations across 6 manufacturers in the TuningBot DTC database.
ChryslerThe control module detected improper operation of the Cylinder cut - out solenoid 4. This is the manufacturer-specific definition used by Chrysler.
DodgeThe control module detected improper operation of the Cylinder cut - out solenoid 4. This is the manufacturer-specific definition used by Dodge.
FordThe control module detected that the signal in the Secondary Air Injection System Monitor circuit stayed above the expected operating range. This is the manufacturer-specific definition used by Ford.
JeepThe control module detected improper operation of the Cylinder cut - out solenoid 4. This is the manufacturer-specific definition used by Jeep.
Land RoverThe control module detected a fault associated with the Secondary air injection (AIR) system, bank 1 - low flow circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Land Rover.
VAGThe control module detected a condition consistent with a leak affecting the Secondary air injection (AIR) system, Bank 2. This is the manufacturer-specific definition used by Audi.
The control module detected a condition consistent with a leak affecting the Secondary air injection (AIR) system. This is the manufacturer-specific definition used by Volkswagen.
Powertrain: engine, transmission and driveline systems.
Manufacturer-defined range: the meaning can differ between brands.
Specific fault index within the subsystem.
Diagnostic Trouble Code (7 interpretations). The control module detected improper operation of the Cylinder cut - out solenoid 4. This is the manufacturer-specific definition used by Chrysler.
P1414 is a manufacturer-specific code. In this database it is documented for: Chrysler, Dodge, Ford, Jeep, Land Rover, VAG. The same number can mean something different on other brands.
If the fault logic lives in the ECU calibration, yes: our DTC Removal file service disables the specific fault entry and, where the ECU needs it, corrects the checksum too. Not sure whether your case qualifies? Request a free assessment and our engineers will check your ECU file.
Understand the system behind this code: Secondary Air System
ItalianoIT
DeutschDE
EspañolES
PortuguêsPT
FrançaisFR
РусскийRU