The control module detected a fault associated with the HO2S Bank 2 Sensor 3 Lean System Or Low Voltage circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Chevrolet.
Base de dados DTC TuningBot · v4.41.2
P1163 Código de avaria de diagnóstico (9 interpretações)
9 interpretações específicas do fabricante em 8 fabricantes na base de dados DTC TuningBot.
Chevrolet
1 interpretação
Chrysler
1 interpretaçãoThe control module detected a fault associated with the HO2S Bank 2 Sensor 3 Lean System Or Low Voltage circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Chrysler.
Verificações recomendadas
- Perform a full module scan
- Review freeze-frame and occurrence data
- Confirm the exact vehicle, ECU and software context
- Inspect relevant wiring and connectors
- Check applicable OEM service information
Land Rover
1 interpretaçãoThe control module detected improper operation of the Heated oxygen sensor (HO2S), too rich, bank 2 circuit. This is the manufacturer-specific definition used by Land Rover.
Causas possíveis
- Wiring
- H025
- ECM
Mercedes-Benz
1 interpretaçãoThe control module detected improper operation of the Engine oil level switch. This is the manufacturer-specific definition used by Mercedes-Benz.
Causas possíveis
- Wiring
- engine oil level switch
- ECM
MINI
1 interpretaçãoThe control module detected a fault associated with the Fuel Trim Additive Per Ignition Bank 1 High circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by MINI.
Nissan
1 interpretaçãoThe control module detected a fault associated with the Heated oxygen sensor (HO2S) 1, bank 2 - lean shift monitoring circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Nissan.
Causas possíveis
- Wiring
- HO2S
- fuel system
- injector
- air leak
- ECM
PSA
1 interpretaçãoThe control module detected the fault condition "The engine has not encountered the conditions to reset the injector dead times (Rail pressure low)" for the Injectors control. Documented for the Delphi DCM 3.5 injection ECU (DW10C 2.0 HDi) on Peugeot applications; the same PSA control units are also fitted to Citroën models.
VAG
2 interpretaçõesThe control module detected an interruption (open circuit) in the Fuel temperature circuit, so the expected electrical continuity was not present. This is the manufacturer-specific definition used by Audi.
Causas possíveis
- Wiring open circuit/short to positive
- fuel temperature sensor
The control module detected a short circuit to battery voltage in the Fuel Temp Sensor (G81): Open or circuit. This is the manufacturer-specific definition used by Volkswagen. Volkswagen Group tools also report it as fault code 17571. Documented across Volkswagen Group applications (Audi, SEAT and Škoda included).
Sintomas
- Fuel consumption higher then normal
- Starting the engine is not as easy as normal
- Emission Levels not met
Causas possíveis
- Wiring/Connectors from/to Fuel Temp Sensor (G81) faulty
- Fuel Temp Sensor (G81) faulty
Verificações recomendadas
- Check Wiring/Connectors from/to Fuel Temp Sensor (G81)
- Check Fuel Temp Sensor (G81)
Códigos relacionados e próximos
Como se lê P1163
Motor e transmissão: motor, caixa e transmissão.
Intervalo definido pelo fabricante: o significado pode variar entre marcas.
Índice específico da avaria dentro do subsistema.
Perguntas frequentes sobre P1163
O que significa P1163?
Código de avaria de diagnóstico (9 interpretações). The control module detected a fault associated with the HO2S Bank 2 Sensor 3 Lean System Or Low Voltage circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Chevrolet.
P1163 é genérico ou específico do fabricante?
P1163 é um código específico do fabricante. Nesta base de dados está documentado para: Chevrolet, Chrysler, Land Rover, Mercedes-Benz, MINI, Nissan, PSA, VAG. O mesmo número pode significar outra coisa noutras marcas.
A TuningBot consegue remover P1163 ao nível do ficheiro?
Se a lógica da avaria vive na calibração da ECU, sim: o nosso serviço DTC Removal desativa a entrada de avaria específica. A correção do checksum não está incluída: é um serviço à parte e opcional. Não sabe se o seu caso se aplica? Peça uma avaliação gratuita e os nossos engenheiros verificam o seu ficheiro.
Outros serviços de ficheiro
Entenda o sistema por trás deste código: Sondas lambda
