TuningBot DTC Database · v4.37.15
9 manufacturer-specific interpretations across 8 manufacturers in the TuningBot DTC database.
Alfa RomeoThe control module detected a fault associated with the Output stage of ECU for variable valve timing circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Alfa Romeo.
ChevroletThe control module detected a fault associated with the Intake Plenum Switchover Valve circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Chevrolet.
ChryslerThe control module detected a fault associated with the Intake Plenum Switchover Valve circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Chrysler.
FordThe control module detected a fault associated with the Alternator Load Input Failed Low circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Ford.
Land RoverThe control module detected that the Alternator, load input voltage stayed above the expected range. This is the manufacturer-specific definition used by Land Rover.
MazdaThe control module detected that the Generator/regulator system - load input value was outside the valid range. This is the manufacturer-specific definition used by Mazda.
MitsubishiThe control module registered the fault condition described as "Engine control module (ECM) - RAM error". This is the manufacturer-specific definition used by Mitsubishi.
ECM
VAGThe control module detected a short circuit to ground in the Injector needle lift circuit. This is the manufacturer-specific definition used by Audi.
The control module detected a short circuit to ground in the Needle Lift Sensor (G80) circuit. This is the manufacturer-specific definition used by Volkswagen. Volkswagen Group tools also report it as fault code 17653. Documented across Volkswagen Group applications (Audi, SEAT and Škoda included).
Powertrain: engine, transmission and driveline systems.
Manufacturer-defined range: the meaning can differ between brands.
Specific fault index within the subsystem.
Diagnostic Trouble Code (9 interpretations). The control module detected a fault associated with the Output stage of ECU for variable valve timing circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Alfa Romeo.
P1245 is a manufacturer-specific code. In this database it is documented for: Alfa Romeo, Chevrolet, Chrysler, Ford, Land Rover, Mazda, Mitsubishi, VAG. The same number can mean something different on other brands.
If the fault logic lives in the ECU calibration, yes: our DTC Removal file service disables the specific fault entry. Checksum correction is not included: it is a separate, optional service. Not sure whether your case qualifies? Request a free assessment and our engineers will check your ECU file.
Understand the system behind this code: Diagnostic Strategy and DTC Logic
ItalianoIT
DeutschDE
EspañolES
PortuguêsPT
FrançaisFR
РусскийRU