The control module detected improper operation of the Wheel Speed Sensor 1 G circuit. This is the manufacturer-specific definition used by Chevrolet.
TuningBot DTC-Datenbank · v4.40.3
P1390 Diagnose-Fehlercode (4 Interpretationen)
4 herstellerspezifische Interpretationen bei 4 Herstellern in der TuningBot DTC-Datenbank.
Chevrolet
1 Interpretation
Ford
1 InterpretationThe control module detected a fault associated with the Octane Adjust Out of Self - Test Range circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Ford.
Empfohlene Prüfungen
- Perform a full module scan
- Review freeze-frame and occurrence data
- Compare commanded and measured values
- Check applicable OEM service information
Honda
1 InterpretationThe control module detected that the G - sensor - intermittent voltage stayed below the expected range. This is the manufacturer-specific definition used by Honda.
Mögliche Ursachen
- Wiring
- G - sensor
Mitsubishi
1 InterpretationThe control module detected a fault associated with the Timing Belt Skipped 1 Tooth Or More circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Mitsubishi.
Verwandte und benachbarte Codes
So liest man P1390
Antriebsstrang: Motor, Getriebe und Antrieb.
Herstellerdefinierter Bereich: die Bedeutung kann je Marke abweichen.
Spezifischer Fehlerindex innerhalb des Subsystems.
Häufige Fragen zu P1390
Was bedeutet P1390?
Diagnose-Fehlercode (4 Interpretationen). The control module detected improper operation of the Wheel Speed Sensor 1 G circuit. This is the manufacturer-specific definition used by Chevrolet.
Ist P1390 generisch oder herstellerspezifisch?
P1390 ist ein herstellerspezifischer Code. In dieser Datenbank ist er dokumentiert für: Chevrolet, Ford, Honda, Mitsubishi. Dieselbe Nummer kann bei anderen Marken etwas anderes bedeuten.
Kann TuningBot P1390 auf Dateiebene entfernen?
Wenn die Fehlerlogik in der Steuergerätekalibrierung liegt, ja: unser DTC-Removal-Dienst deaktiviert den konkreten Fehlereintrag. Die Checksum-Korrektur ist nicht enthalten: Sie ist ein separater, optionaler Service. Unsicher, ob Ihr Fall dazugehört? Fordern Sie eine kostenlose Einschätzung an, und unsere Ingenieure prüfen Ihre Datei.
Weitere Dateidienste
Das System hinter diesem Code verstehen: Diagnosestrategie und DTC-Logik
