Intake Manifold Runner Position Sensor/Switch Circuit Bank 2
Genérico · engine
Fiabilidad del dato85%
The control module detected a fault associated with the Intake Manifold Runner Position Sensor/Switch Circuit Bank 2 circuit or function; the stored code identifies the affected component rather than a single failure mode.
Posibles causas
Wiring
intake manifold air control actuator position sensor/switch
IMRC Position Sensor Circuit Low, Bank 2
Ford · engine
Fiabilidad del dato94%
Ford documents P2019:11 (circuit short to ground) for its 2024-2025 gasoline-engine OBD monitor strategy as imrc position sensor circuit low, bank 2. This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.
Comprobaciones recomendadas
Perform a full module scan
Review freeze-frame and occurrence data
Inspect relevant wiring and connectors
Check power supplies and grounds
Compare commanded and measured values
Check applicable OEM service information
Se aplica aFord gasoline-engine OBD applications|2024-2025 model years
P2019:15
IMRC Position Sensor Circuit High, Bank 2
Ford · engine
Fiabilidad del dato94%
Ford documents P2019:15 for its 2024-2025 gasoline-engine OBD monitor strategy as imrc position sensor circuit high, bank 2. This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.
Comprobaciones recomendadas
Perform a full module scan
Review freeze-frame and occurrence data
Inspect relevant wiring and connectors
Check power supplies and grounds
Compare commanded and measured values
Check applicable OEM service information
Se aplica aFord gasoline-engine OBD applications|2024-2025 model years
P2019:92
IMRC Position Sensor Over Travel, Bank 2
Ford · engine
Fiabilidad del dato94%
Ford documents P2019:92 for its 2024-2025 gasoline-engine OBD monitor strategy as imrc position sensor over travel, bank 2. This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.
Comprobaciones recomendadas
Perform a full module scan
Review freeze-frame and occurrence data
Compare commanded and measured values
Check applicable OEM service information
Se aplica aFord gasoline-engine OBD applications|2024-2025 model years
Código genérico estándar SAE: mismo significado en cualquier marca.
019
Índice específico del fallo dentro del subsistema.
Preguntas frecuentes sobre P2019
¿Qué significa P2019?
Código de avería diagnóstico (3 variantes). The control module detected a fault associated with the Intake Manifold Runner Position Sensor/Switch Circuit Bank 2 circuit or function; the stored code identifies the affected component rather than a single failure mode.
¿P2019 es genérico o específico del fabricante?
P2019 existe tanto como código genérico OBD-II (mismo significado en cualquier marca) como con 1 interpretaciones específicas del fabricante: Ford. Léelo siempre en el contexto de tu vehículo.
¿Puede TuningBot eliminar P2019 a nivel de archivo?
Si la lógica del fallo vive en la calibración de la ECU, sí: nuestro servicio DTC Removal desactiva la entrada de fallo concreta y, si la ECU lo requiere, corrige también el checksum. ¿No sabes si tu caso encaja? Solicita una valoración gratuita y nuestros ingenieros revisarán tu archivo.