Часы работы: 07–23 ежедневно

База данных DTC TuningBot · v4.37.14

P2019 Диагностический код неисправности (3 вариантов)

Общая (OBD-II) интерпретация + 1 специфичных для производителя в базе DTC TuningBot.

P · Силовой агрегатEngineOBD2
Страницы по маркам:Ford

Общая (OBD-II) интерпретация

P2019
Intake Manifold Runner Position Sensor/Switch Circuit Bank 2 Общий · engine Достоверность данных 85%

The control module detected a fault associated with the Intake Manifold Runner Position Sensor/Switch Circuit Bank 2 circuit or function; the stored code identifies the affected component rather than a single failure mode.

Возможные причины

  • Wiring
  • intake manifold air control actuator position sensor/switch

Интерпретации производителей

Ford

3 интерпретаций
P2019:11
IMRC Position Sensor Circuit Low, Bank 2 Ford · engine Достоверность данных 94%

Ford documents P2019:11 (circuit short to ground) for its 2024-2025 gasoline-engine OBD monitor strategy as imrc position sensor circuit low, bank 2. This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.

Рекомендуемые проверки

  • Perform a full module scan
  • Review freeze-frame and occurrence data
  • Inspect relevant wiring and connectors
  • Check power supplies and grounds
  • Compare commanded and measured values
  • Check applicable OEM service information
Применимо к Ford gasoline-engine OBD applications|2024-2025 model years
P2019:15
IMRC Position Sensor Circuit High, Bank 2 Ford · engine Достоверность данных 94%

Ford documents P2019:15 for its 2024-2025 gasoline-engine OBD monitor strategy as imrc position sensor circuit high, bank 2. This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.

Рекомендуемые проверки

  • Perform a full module scan
  • Review freeze-frame and occurrence data
  • Inspect relevant wiring and connectors
  • Check power supplies and grounds
  • Compare commanded and measured values
  • Check applicable OEM service information
Применимо к Ford gasoline-engine OBD applications|2024-2025 model years
P2019:92
IMRC Position Sensor Over Travel, Bank 2 Ford · engine Достоверность данных 94%

Ford documents P2019:92 for its 2024-2025 gasoline-engine OBD monitor strategy as imrc position sensor over travel, bank 2. This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.

Рекомендуемые проверки

  • Perform a full module scan
  • Review freeze-frame and occurrence data
  • Compare commanded and measured values
  • Check applicable OEM service information
Применимо к Ford gasoline-engine OBD applications|2024-2025 model years

Связанные и соседние коды

Как читать P2019

P

Силовой агрегат: двигатель, коробка и трансмиссия.

2

Общий код стандарта SAE: одинаковое значение у всех марок.

019

Конкретный индекс неисправности внутри подсистемы.

Частые вопросы о P2019

Что означает P2019?

Диагностический код неисправности (3 вариантов). The control module detected a fault associated with the Intake Manifold Runner Position Sensor/Switch Circuit Bank 2 circuit or function; the stored code identifies the affected component rather than a single failure mode.

P2019 — общий код или специфичный для производителя?

P2019 существует и как общий код OBD-II (одинаковое значение у всех марок), и с 1 интерпретациями производителей: Ford. Всегда читайте его в контексте вашего автомобиля.

Может ли TuningBot удалить P2019 на уровне файла?

Если логика неисправности заложена в калибровке ЭБУ — да: наша услуга DTC Removal отключает конкретную запись ошибки и, если ЭБУ этого требует, пересчитывает и checksum. Не уверены, подходит ли ваш случай? Запросите бесплатную оценку, и наши инженеры проверят ваш файл.

Другие услуги по файлу

Чип-тюнингРезультаты Stage 1 на стенде для двигателей Ford Смотреть результаты →

← Искать по всей базе DTC