TuningBot DTC Database · v4.37.15
Generic (OBD-II) interpretation + 1 manufacturer-specific in the TuningBot DTC database.
FordThe control module detected a fault associated with the Intake Manifold Runner Position Sensor/Switch Circuit Bank 2 circuit or function; the stored code identifies the affected component rather than a single failure mode.
FordFord documents P2019:11 (circuit short to ground) for its 2024-2025 gasoline-engine OBD monitor strategy as imrc position sensor circuit low, bank 2. This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.
Ford documents P2019:15 for its 2024-2025 gasoline-engine OBD monitor strategy as imrc position sensor circuit high, bank 2. This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.
Ford documents P2019:92 for its 2024-2025 gasoline-engine OBD monitor strategy as imrc position sensor over travel, bank 2. This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.
Powertrain: engine, transmission and driveline systems.
Generic SAE-standard code: same meaning on every make.
Specific fault index within the subsystem.
Diagnostic Trouble Code (3 variants). The control module detected a fault associated with the Intake Manifold Runner Position Sensor/Switch Circuit Bank 2 circuit or function; the stored code identifies the affected component rather than a single failure mode.
P2019 exists both as a generic OBD-II code (same meaning on every make) and with 1 manufacturer-specific interpretation(s): Ford. Always read it in the context of your vehicle.
If the fault logic lives in the ECU calibration, yes: our DTC Removal file service disables the specific fault entry. Checksum correction is not included: it is a separate, optional service. Not sure whether your case qualifies? Request a free assessment and our engineers will check your ECU file.
Understand the system behind this code: Swirl Flaps
ItalianoIT
DeutschDE
EspañolES
PortuguêsPT
FrançaisFR
РусскийRU