The control module detected a fault associated with the O2 Sensor Heater Circuit Signal Intermittent Bank 1 Sensor 2 circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by BMW.
Base de datos DTC de TuningBot · v4.37.15
P1051 Código de avería diagnóstico (4 interpretaciones)
4 interpretaciones específicas del fabricante en 4 fabricantes, en la base de datos DTC de TuningBot.
BMW
1 interpretación
Dodge
1 interpretaciónThe control module detected a fault associated with the Heated oxygen sensor (HO2S) 2, bank 1 inactive circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Dodge.
Posibles causas
- Wiring
- connectors
- HO2S
- ECM
Ford
1 interpretaciónThe control module did not receive the expected Brake Switch signal. This is the manufacturer-specific definition used by Ford.
Comprobaciones recomendadas
- Perform a full module scan
- Review freeze-frame and occurrence data
- Compare commanded and measured values
- Check applicable OEM service information
Nissan
1 interpretaciónThe control module detected that the Heated oxygen sensor (HO2S), bank 2, heater voltage stayed below the expected range. This is the manufacturer-specific definition used by Nissan.
Posibles causas
- Wiring
- HO2S
Códigos relacionados y cercanos
Cómo se lee P1051
Motor y transmisión: motor, cambio y transmisión.
Rango definido por el fabricante: el significado puede variar entre marcas.
Índice específico del fallo dentro del subsistema.
Preguntas frecuentes sobre P1051
¿Qué significa P1051?
Código de avería diagnóstico (4 interpretaciones). The control module detected a fault associated with the O2 Sensor Heater Circuit Signal Intermittent Bank 1 Sensor 2 circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by BMW.
¿P1051 es genérico o específico del fabricante?
P1051 es un código específico del fabricante. En esta base de datos está documentado para: BMW, Dodge, Ford, Nissan. El mismo número puede significar otra cosa en otras marcas.
¿Puede TuningBot eliminar P1051 a nivel de archivo?
Si la lógica del fallo vive en la calibración de la ECU, sí: nuestro servicio DTC Removal desactiva la entrada de fallo concreta. La corrección del checksum no está incluida: es un servicio aparte y opcional. ¿No sabes si tu caso encaja? Solicita una valoración gratuita y nuestros ingenieros revisarán tu archivo.
Otros servicios de archivo
Entender el sistema detrás de este código: Sondas lambda
