The control module stopped receiving expected network messages from the Throttle/Pedal Position Sensor/Switch A node on the vehicle communication bus.
Base de données DTC TuningBot · v4.37.15
U0606 Code défaut de diagnostic (3 variantes)
Interprétation générique (OBD-II) + 1 spécifiques au constructeur dans la base DTC TuningBot.
Interprétation générique (OBD-II)
Interprétations spécifiques au constructeur
Ford
3 interprétationsFord documents U0606:16 (circuit voltage below threshold) for its 2024-2025 gasoline-engine OBD monitor strategy as throttle/pedal position sensor/switch "a" communication circuit low. This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.
Vérifications recommandées
- Perform a full module scan
- Review freeze-frame and occurrence data
- Inspect relevant wiring and connectors
- Check power supplies and grounds
- Compare commanded and measured values
- Check applicable OEM service information
Ford documents U0606:17 (circuit voltage above threshold) for its 2024-2025 gasoline-engine OBD monitor strategy as throttle/pedal position sensor/switch "a" communication circuit high. This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.
Vérifications recommandées
- Perform a full module scan
- Review freeze-frame and occurrence data
- Inspect relevant wiring and connectors
- Check power supplies and grounds
- Compare commanded and measured values
- Check applicable OEM service information
Ford documents U0606:81 for its 2024-2025 gasoline-engine OBD monitor strategy as lost communication with throttle/pedal position sensor/switch "a". This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.
Vérifications recommandées
- Perform a full module scan
- Verify battery voltage
- Check module power supplies and grounds
- Inspect network wiring and connectors
- Measure network resistance with power isolated
- Check applicable OEM service information
Codes liés et voisins
Comment lire U0606
Réseau : communication entre calculateurs.
Code générique standard SAE : même signification sur toutes les marques.
Index de défaut spécifique dans le sous-système.
Questions fréquentes sur U0606
Que signifie U0606 ?
Code défaut de diagnostic (3 variantes). The control module stopped receiving expected network messages from the Throttle/Pedal Position Sensor/Switch A node on the vehicle communication bus.
U0606 est-il générique ou spécifique au constructeur ?
U0606 existe à la fois comme code générique OBD-II (même signification sur toutes les marques) et avec 1 interprétations spécifiques au constructeur : Ford. À lire toujours dans le contexte de votre véhicule.
TuningBot peut-il supprimer U0606 au niveau du fichier ?
Non garanti. Les codes powertrain (P) se désactivent de façon fiable dans la calibration, mais les codes carrosserie, châssis et réseau dépendent du calculateur et de la façon dont le défaut est implémenté - certains sont traitables, d'autres non. Demandez un devis et nos ingénieurs examineront votre fichier et vous diront gratuitement si U0606 est supprimable dans votre cas.
Autres services fichier
Comprendre le système derrière ce code : Commande de papillon
