TuningBot DTC Database · v4.37.14
5 manufacturer-specific interpretations across 5 manufacturers in the TuningBot DTC database.
HyundaiThe control module detected a fault associated with the #3 Ion Line Open circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Hyundai.
LexusThe control module detected improper operation of the Camshaft position (CMP) sensor, circuit A, high input circuit. This is the manufacturer-specific definition used by Lexus.
MINIThe control module detected a fault associated with the Misfire Cylinder 1 With Fuel Cut - off circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by MINI.
ToyotaThe control module detected that the Camshaft Position Sensor 'A' signal stayed above the expected range. This is the manufacturer-specific definition used by Toyota.
VAGThe control module detected a short circuit to ground in the Ignition amplifier, primary circuit 2 circuit. This is the manufacturer-specific definition used by Audi.
Powertrain: engine, transmission and driveline systems.
Manufacturer-defined range: the meaning can differ between brands.
Specific fault index within the subsystem.
Diagnostic Trouble Code (5 interpretations). The control module detected a fault associated with the #3 Ion Line Open circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Hyundai.
P1343 is a manufacturer-specific code. In this database it is documented for: Hyundai, Lexus, MINI, Toyota, VAG. The same number can mean something different on other brands.
If the fault logic lives in the ECU calibration, yes: our DTC Removal file service disables the specific fault entry and, where the ECU needs it, corrects the checksum too. Not sure whether your case qualifies? Request a free assessment and our engineers will check your ECU file.
Understand the system behind this code: Diagnostic Strategy and DTC Logic
ItalianoIT
DeutschDE
EspañolES
PortuguêsPT
FrançaisFR
РусскийRU