TuningBot DTC Database · v4.37.15
4 manufacturer-specific interpretations across 3 manufacturers in the TuningBot DTC database.
BMWThe control module detected that the O2 Sensor responded more slowly than expected. This is the manufacturer-specific definition used by BMW.
DodgeThe control module detected that the signal in the Ignition coil, 5 - secondary circuit stayed below the expected operating range. This is the manufacturer-specific definition used by Dodge.
VAGThe control module detected a fault associated with the Nitrogen oxides (NOx) sensor - signal outside tolerance circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Audi.
The control module detected a fault associated with the Nitrogen oxides (NOx) sensor - signal outside tolerance circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Volkswagen.
Powertrain: engine, transmission and driveline systems.
Manufacturer-defined range: the meaning can differ between brands.
Specific fault index within the subsystem.
Diagnostic Trouble Code (4 interpretations). The control module detected that the O2 Sensor responded more slowly than expected. This is the manufacturer-specific definition used by BMW.
P1034 is a manufacturer-specific code. In this database it is documented for: BMW, Dodge, VAG. The same number can mean something different on other brands.
If the fault logic lives in the ECU calibration, yes: our DTC Removal file service disables the specific fault entry. Checksum correction is not included: it is a separate, optional service. Not sure whether your case qualifies? Request a free assessment and our engineers will check your ECU file.
Understand the system behind this code: Oxygen Sensors (Lambda)
ItalianoIT
DeutschDE
EspañolES
PortuguêsPT
FrançaisFR
РусскийRU