TuningBot DTC-Datenbank · v4.37.15
12 herstellerspezifische Interpretationen bei 11 Herstellern in der TuningBot DTC-Datenbank.
FordThe control module registered the fault condition described as "Idle Air Control Under Speed Error". This is the manufacturer-specific definition used by Ford.
HyundaiThe control module detected that the Idle Speed Control Actuator signal stayed below the expected range. This is the manufacturer-specific definition used by Hyundai.
JaguarThe control module detected that the Idle air control (IAC) valve - RPM value was higher than expected for the current conditions. This is the manufacturer-specific definition used by Jaguar.
KiaThe control module detected that the Idle air control (IAC) valve - closing coil signal stayed below the expected range. This is the manufacturer-specific definition used by Kia.
Land RoverThe control module detected a fault associated with the Idle air control (IAC) - value low circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Land Rover.
LexusThe control module detected a fault associated with the PTC AC Auxiliary Heater Disabled Low circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Lexus.
MazdaThe control module registered the fault condition described as "Idle air control (IAC) system - underspeed error". This is the manufacturer-specific definition used by Mazda.
MINIThe control module detected that the Idle Speed Control Valve Open Solenoid Control signal stayed below the expected range. This is the manufacturer-specific definition used by MINI.
MitsubishiThe control module detected that the Idle air control (IAC) valve - RPM value was higher than expected for the current conditions. This is the manufacturer-specific definition used by Mitsubishi.
SubaruThe control module detected improper operation of the Idle air (IAC) control system. This is the manufacturer-specific definition used by Subaru.
VAGThe control module detected that the Idle speed control (ISC) value was below the expected limit. This is the manufacturer-specific definition used by Audi.
The control module detected that the monitored Idle Control Sys: Lower Regulation value reached its permissible limit. This is the manufacturer-specific definition used by Volkswagen. Volkswagen Group tools also report it as fault code 17915. Documented across Volkswagen Group applications (Audi, SEAT and Škoda included).
Increased Idle Speed
Unmetered Air before Throttle Body
Check Air Intake System
Antriebsstrang: Motor, Getriebe und Antrieb.
Herstellerdefinierter Bereich: die Bedeutung kann je Marke abweichen.
Spezifischer Fehlerindex innerhalb des Subsystems.
Diagnose-Fehlercode (12 Interpretationen). The control module registered the fault condition described as "Idle Air Control Under Speed Error". This is the manufacturer-specific definition used by Ford.
P1507 ist ein herstellerspezifischer Code. In dieser Datenbank ist er dokumentiert für: Ford, Hyundai, Jaguar, Kia, Land Rover, Lexus, Mazda, MINI, Mitsubishi, Subaru, VAG. Dieselbe Nummer kann bei anderen Marken etwas anderes bedeuten.
Wenn die Fehlerlogik in der Steuergerätekalibrierung liegt, ja: unser DTC-Removal-Dienst deaktiviert den konkreten Fehlereintrag. Die Checksum-Korrektur ist nicht enthalten: Sie ist ein separater, optionaler Service. Unsicher, ob Ihr Fall dazugehört? Fordern Sie eine kostenlose Einschätzung an, und unsere Ingenieure prüfen Ihre Datei.
Das System hinter diesem Code verstehen: Diagnosestrategie und DTC-Logik
EnglishEN
ItalianoIT
EspañolES
PortuguêsPT
FrançaisFR
РусскийRU