TuningBot DTC Database · v4.37.14
4 manufacturer-specific interpretations across 3 manufacturers in the TuningBot DTC database.
FordThe control module detected a fault associated with the Cylinder #8 High To Low Side Short circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Ford.
Wiring short circuit
VAGThe control module determined that the Injector 3 - control adaptation reached its permissible limit. This is the manufacturer-specific definition used by Audi.
The control module determined that the Injector 3 - control adaptation reached its permissible limit. This is the manufacturer-specific definition used by Volkswagen.
VolvoThe control module detected that the Turbocharger (TC) boost pressure signal stayed below the expected range. This is the manufacturer-specific definition used by Volvo.
Powertrain: engine, transmission and driveline systems.
Manufacturer-defined range: the meaning can differ between brands.
Specific fault index within the subsystem.
Diagnostic Trouble Code (4 interpretations). The control module detected a fault associated with the Cylinder #8 High To Low Side Short circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Ford.
P1268 is a manufacturer-specific code. In this database it is documented for: Ford, VAG, Volvo. The same number can mean something different on other brands.
If the fault logic lives in the ECU calibration, yes: our DTC Removal file service disables the specific fault entry and, where the ECU needs it, corrects the checksum too. Not sure whether your case qualifies? Request a free assessment and our engineers will check your ECU file.
Understand the system behind this code: Diagnostic Strategy and DTC Logic
ItalianoIT
DeutschDE
EspañolES
PortuguêsPT
FrançaisFR
РусскийRU