TuningBot DTC Database · v4.37.14
2 manufacturer-specific interpretations across 2 manufacturers in the TuningBot DTC database.
BMWThe control module detected that the signal in the O2 Sensor Heater circuit stayed below the expected operating range. This is the manufacturer-specific definition used by BMW.
DodgeThe control module detected a fault associated with the Change In MAP Reading Out Of Limits circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Dodge.
Powertrain: engine, transmission and driveline systems.
Manufacturer-defined range: the meaning can differ between brands.
Specific fault index within the subsystem.
Diagnostic Trouble Code (2 interpretations). The control module detected that the signal in the O2 Sensor Heater circuit stayed below the expected operating range. This is the manufacturer-specific definition used by BMW.
P1060 is a manufacturer-specific code. In this database it is documented for: BMW, Dodge. The same number can mean something different on other brands.
If the fault logic lives in the ECU calibration, yes: our DTC Removal file service disables the specific fault entry and, where the ECU needs it, corrects the checksum too. Not sure whether your case qualifies? Request a free assessment and our engineers will check your ECU file.
Understand the system behind this code: Oxygen Sensors (Lambda)
ItalianoIT
DeutschDE
EspañolES
PortuguêsPT
FrançaisFR
РусскийRU