TuningBot DTC Database · v4.37.15
4 manufacturer-specific interpretations across 3 manufacturers in the TuningBot DTC database.
BMWThe control module detected a fault associated with the O2 Sensor Circuit Slow Switching From Lean to Rich Bank 2 Sensor 1 circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by BMW.
DodgeThe control module detected that the signal in the Ignition coil, 5 - secondary circuit stayed above the expected operating range. This is the manufacturer-specific definition used by Dodge.
VAGThe control module detected that the Nitrogen oxides (NOx) value was below the expected limit. This is the manufacturer-specific definition used by Audi.
The control module detected that the Nitrogen oxides (NOx) value was below the expected limit. This is the manufacturer-specific definition used by Volkswagen.
Powertrain: engine, transmission and driveline systems.
Manufacturer-defined range: the meaning can differ between brands.
Specific fault index within the subsystem.
Diagnostic Trouble Code (4 interpretations). The control module detected a fault associated with the O2 Sensor Circuit Slow Switching From Lean to Rich Bank 2 Sensor 1 circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by BMW.
P1033 is a manufacturer-specific code. In this database it is documented for: BMW, Dodge, VAG. The same number can mean something different on other brands.
If the fault logic lives in the ECU calibration, yes: our DTC Removal file service disables the specific fault entry. Checksum correction is not included: it is a separate, optional service. Not sure whether your case qualifies? Request a free assessment and our engineers will check your ECU file.
Understand the system behind this code: Oxygen Sensors (Lambda)
ItalianoIT
DeutschDE
EspañolES
PortuguêsPT
FrançaisFR
РусскийRU