The control module detected that the WT overload protection signal stayed above the expected range. This is the manufacturer-specific definition used by BMW.
Causas possíveis
- Mechanical fault
- servo motor short circuit
- servo motor shorted to ground
Base de dados DTC TuningBot · v4.41.2
8 interpretações específicas do fabricante em 8 fabricantes na base de dados DTC TuningBot.
The control module detected that the WT overload protection signal stayed above the expected range. This is the manufacturer-specific definition used by BMW.
The control module detected that the signal in the Cruise Control Clutch Control circuit stayed above the expected operating range. This is the manufacturer-specific definition used by Chevrolet.
The control module detected that the signal in the Cruise Control Clutch Control circuit stayed above the expected operating range. This is the manufacturer-specific definition used by Chrysler.
The control module detected a fault associated with the Throttle Control Unit Detected Loss of Return Spring circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Ford.
The control module detected that the signal in the Motor power inverter module - current circuit stayed above the expected operating range. This is the manufacturer-specific definition used by Honda.
The control module detected improper operation of the CAN data bus, central locking control module - ·. This is the manufacturer-specific definition used by Mercedes-Benz.
Wiring
The stored code identifies a fault of the Gear selection actuator position sensor 2 supply fault. Documented for the Automated manual gearbox electric control ECU on Peugeot applications; the same PSA control units are also fitted to Citroën models. PSA documentation does not characterise the failure mode further.
The control module detected an interruption (open circuit) in the Engine Mount Solenoid Valves circuit, so the expected electrical continuity was not present. This is the manufacturer-specific definition used by Volkswagen.
Motor e transmissão: motor, caixa e transmissão.
Intervalo definido pelo fabricante: o significado pode variar entre marcas.
Índice específico da avaria dentro do subsistema.
Código de avaria de diagnóstico (8 interpretações). The control module detected that the WT overload protection signal stayed above the expected range. This is the manufacturer-specific definition used by BMW.
P1588 é um código específico do fabricante. Nesta base de dados está documentado para: BMW, Chevrolet, Chrysler, Ford, Honda, Mercedes-Benz, PSA, VAG. O mesmo número pode significar outra coisa noutras marcas.
Se a lógica da avaria vive na calibração da ECU, sim: o nosso serviço DTC Removal desativa a entrada de avaria específica. A correção do checksum não está incluída: é um serviço à parte e opcional. Não sabe se o seu caso se aplica? Peça uma avaliação gratuita e os nossos engenheiros verificam o seu ficheiro.
Entenda o sistema por trás deste código: Estratégia de diagnóstico e lógica DTC