P1588 Диагностический код неисправности (8 интерпретаций)

The control module detected that the WT overload protection signal stayed above the expected range. This is the manufacturer-specific definition used by BMW.

The control module detected that the signal in the Cruise Control Clutch Control circuit stayed above the expected operating range. This is the manufacturer-specific definition used by Chevrolet.

The control module detected that the signal in the Cruise Control Clutch Control circuit stayed above the expected operating range. This is the manufacturer-specific definition used by Chrysler.

The control module detected a fault associated with the Throttle Control Unit Detected Loss of Return Spring circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Ford.

The control module detected that the signal in the Motor power inverter module - current circuit stayed above the expected operating range. This is the manufacturer-specific definition used by Honda.

The control module detected improper operation of the CAN data bus, central locking control module - ·. This is the manufacturer-specific definition used by Mercedes-Benz.

The stored code identifies a fault of the Gear selection actuator position sensor 2 supply fault. Documented for the Automated manual gearbox electric control ECU on Peugeot applications; the same PSA control units are also fitted to Citroën models. PSA documentation does not characterise the failure mode further.

The control module detected an interruption (open circuit) in the Engine Mount Solenoid Valves circuit, so the expected electrical continuity was not present. This is the manufacturer-specific definition used by Volkswagen.