Guias de Ajuste

Simos 12 tuning explained: ECU identification, software-specific access, torque control, lambda checks and diagnosing missing gains.

MG1 tuning guide for B58 applications: identify the ECU and software, confirm access, interpret torque control and validate logs.

Injector scaling guide covering pressure reference, flow data, voltage offset, short-pulse behavior and validation without universal scaling rules.

Understand boost by gear tuning: gear detection, wastegate authority, shift transitions and logs for checking torque delivery.

Diesel smoke limiter tuning: understand fuel-mass and lambda limits, identify the active constraint and validate air, injection and transient behavior.

Simos 18 tuning explained: identify hardware and software, distinguish calibration files from backups, and separate checksums, signatures and CVN.

ECU file service cost explained: separate file work from diagnostics, programming and validation, then compare scope, tool requirements and support terms.

HPFP control tuning explained: distinguish GDI and diesel strategies, check low-side supply, interpret rail-pressure logs and validate hardware changes.

Boost control tuning: verify actuator behavior, distinguish base duty from feedback, and diagnose overshoot, creep and control limits using logs.

Continental SID807 tuning: verify ECU identity, protocol coverage, read type and checksum handling before programming and vehicle validation.

Idle control tuning explained: check airflow, fueling and ignition, interpret PID corrections, and validate idle across temperature and accessory loads.

Ford 10R80 workshop playbook: start with conservative software edits, validate with datalogs, and upgrade hardware only if logs show slip or heat.

Identify the MCU, export matching definitions, run checksums, and verify reads before write. Or upload your Keihin file for engineer reviewed calibration.

Bench steps for Tricore boot mode: HWCFG wiring, reset timing, CAN and ASC methods, and TuningBot pre upload checks to prevent bricking.

Practitioner-first lambda target tuning: verify VE and injectors before editing targets, use wideband and dyno verification, and start with the article’s…

Technician workflow for spark advance tuning to hit MBT on the dyno. Use 1–2° timing steps, wideband and knock logging, plus shop ready safety margins.

Shop-ready AutoTuner boot mode workflow for technicians: step by step PCB read and write, probe and power rules, plus when to send raw reads to a file…

Workshop-grade ZF 8HP tuning from the TuningBot team. See what a TCU remap changes, safe software headroom up to 650 lb‑ft, shop workflow, dyno checks,…

Physics first Stage 1 EDC17 reference for professional tuners: fuel and boost physics, DAMOS and firmware checks, and a practical validation checklist.

Guide for tuners on AutoTuner Master, Slave, and backup files. Correct checksums, preserve archive structure, and use TuningBot workflows to avoid bricked…

Engineer focused workshop guide: NOx off tuning with checksum first workflows, prechecks and tests to avoid bricked ECUs and legal risk.