U1109 Codice di errore diagnostico (7 interpretazioni)

The control module detected a fault associated with the Multifunction control module, CAN data bus - time out circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Mitsubishi.

The control module detected that the expected Communication with automatic gearbox ECU fault was absent. Documented for the Automated manual gearbox electric control ECU on Peugeot applications; the same PSA control units are also fitted to Citroën models.

The control module detected that the expected Fault was absent. Documented for the Bosch ESP 8.1 stability control ECU on Peugeot applications; the same PSA control units are also fitted to Citroën models.

The control module detected the fault condition "Communication fault with the gearbox ECU" for the CAN network. Documented for the Bosch MED 17.4.x engine ECU (EP6 THP family) on Peugeot applications; the same PSA control units are also fitted to Citroën models.

The control module detected the fault condition "No communication with the gearbox ECU (Automatic or Electronic)" for the Intersystems CAN. Documented for the Continental SID 807 injection ECU (DV6C 1.6 HDi) on Peugeot applications; the same PSA control units are also fitted to Citroën models.

The control module detected the fault condition "Loss of communication with the gearbox ECU (automatic or piloted manual)" for the Intersystem CAN network. Documented for the Delphi DCM 3.5 injection ECU (DW10C 2.0 HDi) on Peugeot applications; the same PSA control units are also fitted to Citroën models.

The control module detected the fault condition "No communications with the auto gearbox" for the Dialogue with the automatic gearbox. Documented for the Magneti Marelli MM6KP engine ECU (EW7A/EW10A) on Peugeot applications; the same PSA control units are also fitted to Citroën models.