TuningBot DTC Database · v4.37.14
3 manufacturer-specific interpretations across 2 manufacturers in the TuningBot DTC database.
FordThe control module detected a short circuit to ground in the Transmission Pressure Circuit Solenoid Open or circuit. This is the manufacturer-specific definition used by Ford.
VAGThe control module detected a fault associated with the Data bus, ECM 1/2 - software version monitoring circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Audi.
Data in ECM 1 & ECM 2 does not match
The control module detected a fault associated with the Data Bus ECM 1/2 Software Version Monitoring circuit or function; the stored code identifies the affected component rather than a single failure mode. This is the manufacturer-specific definition used by Volkswagen.
Powertrain: engine, transmission and driveline systems.
Manufacturer-defined range: the meaning can differ between brands.
Specific fault index within the subsystem.
Diagnostic Trouble Code (3 interpretations). The control module detected a short circuit to ground in the Transmission Pressure Circuit Solenoid Open or circuit. This is the manufacturer-specific definition used by Ford.
P1908 is a manufacturer-specific code. In this database it is documented for: Ford, VAG. The same number can mean something different on other brands.
If the fault logic lives in the ECU calibration, yes: our DTC Removal file service disables the specific fault entry and, where the ECU needs it, corrects the checksum too. Not sure whether your case qualifies? Request a free assessment and our engineers will check your ECU file.
Understand the system behind this code: Diagnostic Strategy and DTC Logic
ItalianoIT
DeutschDE
EspañolES
PortuguêsPT
FrançaisFR
РусскийRU