BMW 3.0D 24X/25XHP Remap & Chiptuning – 530d E60, X5 3.0d E70, 730d E65

Professional ECU tuning and remapping for the BMW 3.0D 24X/25XHP diesel engine. Our dyno-tested Stage 1 calibrations improve torque delivery, throttle response and drivability, with optional DPF, EGR and AdBlue/SCR solutions for supported ECUs.

Engine codes: N57D30 / M57D30

Fitted to 530d E60X5 3.0d E70730d E65

+37 hp Best Stage 1 power gain

+69 Nm Best Stage 1 torque gain

1 ECU variant covered

Diesel Fuel type

Performance Gains (Dyno-Tested)

Engine	Stock	Tuned	HP Gain	Torque Gain	ECU	Order
3.0D 24X/25XHP	- hp	- hp	+37 hp	+69 Nm	EDC17CP45Stage 1	Order file →

Figures are dyno-tested averages and may vary with hardware condition and fuel quality.

Cars this engine is fitted to

530d E60, X5 3.0d E70, 730d E65, BMW 335d, BMW 335d xDrive, BMW 430d and 16 more

BMW · 14

335d335d xDrive430d 430d xDrive435d xDrive525d 530d E60535d535d xDrive640d730d E65M550d xDriveX4X5 3.0d E70

Fitment is read from the ECU part numbers in our own database, not from a generic catalogue. The same engine and control unit are fitted to several cars, which is why one page serves them all.

Measured here, tunable everywhere

The figures in the table above are readings taken on the dyno for this engine, not software estimates rounded up to sell a file, and our Stage 1 is calibrated to stay inside the margins the engine was designed with. Only a part of our work is published this way: every ECU, engine and model we can read can be remapped for power, measured page or not.

Available ECU Services for this Engine

The following solutions are supported on the ECU(s) of this vehicle (Diesel):

AGS Removal AdBlue DPF DTC Removal EGR Flaps/Swirl Removal Hot Start Fix Immo Removal LaunchControl Readiness Calibration RevLimiter Speed Limiter Removal Sport Displays Calibration StartStop Disable TVA Removal Torque Monitoring Disable

Technical Notes per ECU

Disconnection and read requirements differ by ECU. The notes below apply to the specific ECU listed; the exact removal scope per service is confirmed on each service page.

EDC17CP45

EGR off ACTUATOR PLUG MUST BE DISCONNECTED

DPF off DPF PRESSURE AND TEMPERATURE SENSORS CAN BE DISCONNECTED

AdBlue/SCR off ADBLUE ECU AND PUMP MUST BE DISCONNECTED SENSORS CAN BE DISCONNECTED

General FULL READ REQUIRED

Each note is tagged with the service it refers to and applies to the ECU it is listed under. Mechanical preparation is the installer's responsibility. Emission-related solutions are for off-road or motorsport use where permitted by law.

Supported ECU(s): EDC17CP45

Frequently Asked Questions

How much power can a BMW 3.0D 24X/25XHP gain with Stage 1 tuning?

Stage 1 ECU tuning for the BMW 3.0D 24X/25XHP can add up to +37 hp and +69 Nm of torque, based on dyno-tested calibrations. Actual figures depend on the exact engine variant and hardware condition.

Can DPF, EGR and AdBlue/SCR be removed on the BMW 3.0D 24X/25XHP?

DPF, EGR and AdBlue/SCR off is supported on the ECU(s) of this vehicle, strictly for off-road or motorsport use where permitted by law. The exact mechanical preparation and sensor handling are listed per ECU in the technical notes below.

How do I order and how fast is the tuning file delivered?

Upload your original ECU read through the tuning page and receive the calibration by email. Most files are delivered within 15-20 minutes during working hours (daily, 07:00-23:00 CET).

Is the BMW 3.0D 24X/25XHP tuning file plug-and-play?

You receive a ready-to-flash calibration based on your original file. Flashing it back to the ECU and any related mechanical preparation are handled by the installer with their own tools.

Order your BMW 3.0D 24X/25XHP tuning file

Upload your original ECU file and receive a professional calibration in 15-20 minutes.

Tune Your File →

← See all dyno results

v4.31.23