ItalianoIT
DeutschDE
EspañolES
PortuguêsPT
FrançaisFR
РусскийRU
Land Rover/Jaguar 3.0 INGENIUM Remap & Chiptuning – Range Rover D300, Defender D250, Discovery D300
Professional ECU tuning and remapping for the Land Rover/Jaguar 3.0 INGENIUM diesel engine. Our dyno-tested Stage 1 calibrations improve torque delivery, throttle response and drivability, with optional DPF, EGR and AdBlue/SCR solutions for supported ECUs.
Engine codes: Ingenium 3.0 I6
Fitted to Range Rover D300Defender D250Discovery D300
Performance Gains (Dyno-Tested)
| Engine | Stock | Tuned | HP Gain | Torque Gain | ECU | Order |
|---|---|---|---|---|---|---|
| 3.0 INGENIUM | 249/258 hp | 294/303 hp | +45 hp +17 to +18% | +51 Nm | EDC17CP55Stage 1 | Order file → |
Figures are dyno-tested averages and may vary with hardware condition and fuel quality.
Cars this engine is fitted to
Range Rover D300, Defender D250, Discovery D300 and Jaguar F-pace
Fitment is read from the ECU part numbers in our own database, not from a generic catalogue. The same engine and control unit are fitted to several cars, which is why one page serves them all.Measured here, tunable everywhere
The figures in the table above are readings taken on the dyno for this engine, not software estimates rounded up to sell a file, and our Stage 1 is calibrated to stay inside the margins the engine was designed with. Only a part of our work is published this way: every ECU, engine and model we can read can be remapped for power, measured page or not.
Available ECU Services for this Engine
The following solutions are supported on the ECU(s) of this vehicle (Diesel):
Technical Notes per ECU
Disconnection and read requirements differ by ECU. The notes below apply to the specific ECU listed; the exact removal scope per service is confirmed on each service page.
Each note is tagged with the service it refers to and applies to the ECU it is listed under. Mechanical preparation is the installer's responsibility. Emission-related solutions are for off-road or motorsport use where permitted by law.
Supported ECU(s): EDC17CP55
Frequently Asked Questions
How much power can a Land Rover/Jaguar 3.0 INGENIUM gain with Stage 1 tuning?
Stage 1 ECU tuning for the Land Rover/Jaguar 3.0 INGENIUM can add up to +45 hp and +51 Nm of torque, based on dyno-tested calibrations. Actual figures depend on the exact engine variant and hardware condition.
Can DPF, EGR and AdBlue/SCR be removed on the Land Rover/Jaguar 3.0 INGENIUM?
DPF, EGR and AdBlue/SCR off is supported on the ECU(s) of this vehicle, strictly for off-road or motorsport use where permitted by law. The exact mechanical preparation and sensor handling are listed per ECU in the technical notes below.
How do I order and how fast is the tuning file delivered?
Upload your original ECU read through the tuning page and receive the calibration by email. Most files are delivered within 15-20 minutes during working hours (daily, 07:00-23:00 CET).
Is the Land Rover/Jaguar 3.0 INGENIUM tuning file plug-and-play?
You receive a ready-to-flash calibration based on your original file. Flashing it back to the ECU and any related mechanical preparation are handled by the installer with their own tools.
Order your Land Rover/Jaguar 3.0 INGENIUM tuning file
Upload your original ECU file and receive a professional calibration in 15-20 minutes.
Tune Your File →v4.31.23