ItalianoIT
DeutschDE
EspañolES
PortuguêsPT
FrançaisFR
РусскийRU
Audi Q2 ECU Tuning: Stage 1 Gains by Engine
Dyno-tested Stage 1 results for every Audi Q2 engine we have on the bench. Pick your engine for the full page with ECUs, notes and services, or upload your file straight away.
Stage 1 gains by engine
Best Stage 1 result per engine family on the power variants this model carries; the table below lists the versions matched exactly.
| Engine | Stock | HP Gain | Torque Gain | Details |
|---|---|---|---|---|
| 1.4 TSI petrol | 150 hp | from +21 to +37 hp | +48 Nm | Engine page → |
| 1.5 TSI petrol | 150 hp | +25 hp | +45 Nm | Engine page → |
| 2.0 TSI petrol | 190–200 hp | from +32 to +44 hp | +77 Nm | Engine page → |
Figures are dyno-tested averages and may vary with hardware condition and fuel quality.
Measured by version
Versions of this model whose ECU and stock power match a dyno row exactly: the figure is the one measured on that engine, not a family average.
| Version | Engine | ECU | Stock | HP Gain | Torque Gain | Order |
|---|---|---|---|---|---|---|
| Audi Q2 petrol | 2.0 TSI | MG1CS111 | 190 hp | +40 hp. 230 hp · +21% | +69 Nm | Order file → |
| Audi Q2 petrol | 1.5 TSI | MG1CS011 | 150 hp | +25 hp. 175 hp · +17% | +45 Nm | Order file → |
| Audi Q2 petrol | 1.4 TSI | MED17.5.25 | 150 hp | +21 hp. 171 hp · +14% | +48 Nm | Order file → |
Measured here, tunable everywhere
The Audi Q2 engines listed above are the ones we have run on the dyno, so the figures on their pages are readings rather than software estimates. They are not the limit of what we tune: every ECU, engine and model we can read can be remapped for power, Audi Q2 or otherwise. If your engine is not on this list, upload the original file anyway.
Every figure here was measured on this engine at a stock power your car has, sometimes on another car fitted with the same unit; the per-version table below marks only the exact matches.
Frequently Asked Questions
Which Audi Q2 engines can be remapped?
The 3 engines in the table above were measured on our dyno: 1.4 TSI, 1.5 TSI and 2.0 TSI. Other Audi Q2 engines can be remapped too when we can read the ECU - the table is what we publish, not the limit of the service.
How much power does a Stage 1 add on a Audi Q2?
Between +21 and +40 hp depending on the engine; the best result measured is +40 hp on the 2.0 TSI. Every figure is a dyno reading on stock hardware, not an estimate.
Do I have to send the Audi Q2 ECU?
No. Read the original file with your tool (KESS3, Autotuner, CMD, Dimsport, PCMTuner and others), upload it, and the tuned file comes back in 15-20 minutes to write into the car. Only the file travels.
Order your Audi Q2 tuning file
Upload your original ECU file and receive a professional calibration in 15-20 minutes.
Tune Your File →v4.31.23