Active Grille Air Shutter “B” Position Sensor Minimum/Maximum Stop
Ford · engine
Data confidence94%
Ford documents P05B1:79 for its 2024-2025 gasoline-engine OBD monitor strategy as active grille air shutter “b” position sensor minimum/maximum stop. This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.
Recommended checks
Perform a full module scan
Review freeze-frame and occurrence data
Compare commanded and measured values
Check applicable OEM service information
Applies toFord gasoline-engine OBD applications|2024-2025 model years
P05B1:97
Active Grille Air Shutter “B” Performance/Stuck Off
Ford · engine
Data confidence94%
Ford documents P05B1:97 for its 2024-2025 gasoline-engine OBD monitor strategy as active grille air shutter “b” performance/stuck off. This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.
Recommended checks
Perform a full module scan
Review freeze-frame and occurrence data
Compare commanded and measured values
Check applicable OEM service information
Applies toFord gasoline-engine OBD applications|2024-2025 model years
Powertrain: engine, transmission and driveline systems.
0
Generic SAE-standard code: same meaning on every make.
5B1
Specific fault index within the subsystem.
Frequently asked questions about P05B1
What does P05B1 mean?
Diagnostic Trouble Code (2 variants). Ford documents P05B1:79 for its 2024-2025 gasoline-engine OBD monitor strategy as active grille air shutter “b” position sensor minimum/maximum stop. This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.
Is P05B1 generic or manufacturer-specific?
P05B1 exists both as a generic OBD-II code (same meaning on every make) and with 1 manufacturer-specific interpretation(s): Ford. Always read it in the context of your vehicle.
Can TuningBot remove P05B1 at file level?
If the fault logic lives in the ECU calibration, yes: our DTC Removal file service disables the specific fault entry. Checksum correction is not included: it is a separate, optional service. Not sure whether your case qualifies? Request a free assessment and our engineers will check your ECU file.
ItalianoIT
DeutschDE
EspañolES
PortuguêsPT
FrançaisFR
РусскийRU