TuningBot DTC Database · v4.37.14
Generic (OBD-II) interpretation + 1 manufacturer-specific in the TuningBot DTC database.
FordThe control module detected a fault associated with the Camshaft Position Sensor B Circuit Bank 1 circuit or function; the stored code identifies the affected component rather than a single failure mode.
FordFord documents P0365:01 for its 2024-2025 gasoline-engine OBD monitor strategy as exhaust cam position circuit, bank 1. This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.
Ford documents P0365:02 for its 2024-2025 gasoline-engine OBD monitor strategy as intake cam position circuit intermittent, bank 1. This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.
Powertrain: engine, transmission and driveline systems.
Generic SAE-standard code: same meaning on every make.
Specific fault index within the subsystem.
Diagnostic Trouble Code (2 variants). The control module detected a fault associated with the Camshaft Position Sensor B Circuit Bank 1 circuit or function; the stored code identifies the affected component rather than a single failure mode.
P0365 exists both as a generic OBD-II code (same meaning on every make) and with 1 manufacturer-specific interpretation(s): Ford. Always read it in the context of your vehicle.
If the fault logic lives in the ECU calibration, yes: our DTC Removal file service disables the specific fault entry and, where the ECU needs it, corrects the checksum too. Not sure whether your case qualifies? Request a free assessment and our engineers will check your ECU file.
Understand the system behind this code: Diagnostic Strategy and DTC Logic
ItalianoIT
DeutschDE
EspañolES
PortuguêsPT
FrançaisFR
РусскийRU