general and specific cylinder misfire
Ford · ignition
Data confidence94%
Ford documents P0310:00 (no sub type information) for its 2024-2025 gasoline-engine OBD monitor strategy as general and specific cylinder misfire. This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.
Recommended checks
Perform a full module scan
Review freeze-frame and occurrence data
Compare commanded and measured values
Check applicable OEM service information
Applies toFord gasoline-engine OBD applications|2024-2025 model years
Powertrain: engine, transmission and driveline systems.
0
Generic SAE-standard code: same meaning on every make.
310
Specific fault index within the subsystem.
Frequently asked questions about P0310
What does P0310 mean?
Cylinder 10 Misfire Detected. The control module detected crankshaft speed fluctuations consistent with combustion misfire (Cylinder 10).
Is P0310 generic or manufacturer-specific?
P0310 exists both as a generic OBD-II code (same meaning on every make) and with 1 manufacturer-specific interpretation(s): Ford. Always read it in the context of your vehicle.
Can TuningBot remove P0310 at file level?
If the fault logic lives in the ECU calibration, yes: our DTC Removal file service disables the specific fault entry. Checksum correction is not included: it is a separate, optional service. Not sure whether your case qualifies? Request a free assessment and our engineers will check your ECU file.
ItalianoIT
DeutschDE
EspañolES
PortuguêsPT
FrançaisFR
РусскийRU
Ford