MAP / MAF - Throttle Position Correlation
Generic · engine
Data confidence90%
The control module detected a fault associated with the MAP / MAF - Throttle Position Correlation circuit or function; the stored code identifies the affected component rather than a single failure mode.
Symptoms
MIL illuminated
Possible hesitation or poor throttle response
Possible incorrect fuel trim values
Possible causes
Wiring
MAP sensor
MAF sensor
mechanical fault
Recommended checks
Compare measured air mass with expected values at idle and load
MAP / MAF - Throttle Position Correlation
Ford · engine
Data confidence94%
Ford documents P0068:00 (no sub type information) for its 2024-2025 gasoline-engine OBD monitor strategy as map / maf - throttle position correlation. This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.
Recommended checks
Perform a full module scan
Review freeze-frame and occurrence data
Compare commanded and measured values
Check applicable OEM service information
Applies toFord gasoline-engine OBD applications|2024-2025 model years
P0068:48
Internal Control Module Throttle Actuator Controller Performance
Ford · software
Data confidence94%
Ford documents P0068:48 for its 2024-2025 gasoline-engine OBD monitor strategy as internal control module throttle actuator controller performance. This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.
Recommended checks
Perform a full module scan
Review freeze-frame and occurrence data
Check applicable OEM service information
Applies toFord gasoline-engine OBD applications|2024-2025 model years
Powertrain: engine, transmission and driveline systems.
0
Generic SAE-standard code: same meaning on every make.
068
Specific fault index within the subsystem.
Frequently asked questions about P0068
What does P0068 mean?
Diagnostic Trouble Code (2 variants). The control module detected a fault associated with the MAP / MAF - Throttle Position Correlation circuit or function; the stored code identifies the affected component rather than a single failure mode.
Is P0068 generic or manufacturer-specific?
P0068 exists both as a generic OBD-II code (same meaning on every make) and with 1 manufacturer-specific interpretation(s): Ford. Always read it in the context of your vehicle.
Can TuningBot remove P0068 at file level?
If the fault logic lives in the ECU calibration, yes: our DTC Removal file service disables the specific fault entry and, where the ECU needs it, corrects the checksum too. Not sure whether your case qualifies? Request a free assessment and our engineers will check your ECU file.
ItalianoIT
DeutschDE
EspañolES
PortuguêsPT
FrançaisFR
РусскийRU
Ford