Limp mode (also called safe mode or emergency running) is an ECU protection state activated when critical faults are detected. It limits engine power to prevent damage while allowing the vehicle to be driven to a safe location or repair facility.

Übersicht

When the ECU detects a fault that could cause damage if full power continues, it restricts boost, RPM, and/or torque. The severity of restriction depends on the fault type.

Common Triggers

• Boost control faults
• Torque monitoring errors
• Sensor failures (MAF, MAP, etc.)
• Overtemperature conditions
• Transmission faults
• Throttle system faults

Limp Mode Behaviors

• Boost limited — turbo runs wastegate open
• RPM limited — typically 2500-3500 RPM
• Torque limited — reduced power output
• Speed limited — maximum speed cap
• Single gear — automatic stuck in one gear

Logic Overview

Fault Detected → Severity Assessment
         ↓
Select Appropriate Limp Strategy
         ↓
Apply Restrictions
         ↓
Illuminate MIL / Display Warning
         ↓
Recovery: Clear fault OR key cycle

Calibration Considerations

• Poor tuning can trigger limp mode (torque mismatch)
• Disabled sensors may cause limp mode
• Some limp modes require dealer reset

Diagnostik

• Read DTCs to identify trigger
• Check freeze frame data
• Verify sensor inputs

Best Practices

• Limp mode indicates a real problem — don’t just reset and ignore
• Quality tuning should not trigger limp mode
• Address root cause, not symptoms