Hours: 07–23 daily
EN
Tune your file

TuningBot DTC Database · v4.37.14

U0347 Software Incompatibility With Hybrid/EV Battery Interface Control Module N

Generic (OBD-II) interpretation in the TuningBot DTC database.

U · NetworkNetworkOBD2

What U0347 means

U0347
Software Incompatibility With Hybrid/EV Battery Interface Control Module N Generic · network Data confidence 65%

The control module detected a fault associated with the Software Incompatibility With Hybrid/EV Battery Interface Control Module N circuit or function; the stored code identifies the affected component rather than a single failure mode.

Symptoms

  • Multiple warning lamps possible
  • Functions of the affected module unavailable

Possible causes

  • CAN bus wiring fault (open, short, chafed harness)
  • Faulty control module loading the bus
  • Connector or terminal corrosion
  • Power supply or ground fault of a module

Recommended checks

  • Perform a full-module scan to map which modules communicate
  • Check CAN bus resistance and voltages at the diagnostic connector
  • Inspect wiring and connectors of the affected module
  • Check module power supply and grounds
  • Disconnect suspect modules one at a time only with a documented procedure

Related and nearby codes

U03 range
U0300U0301U0302U0303U0304U0305U0306U0307U0308U0309U030AU030BU030CU030DU030EU030FU0310U0311

How to read U0347

U

Network: communication between control units.

0

Generic SAE-standard code: same meaning on every make.

347

Specific fault index within the subsystem.

Frequently asked questions about U0347

What does U0347 mean?

Software Incompatibility With Hybrid/EV Battery Interface Control Module N. The control module detected a fault associated with the Software Incompatibility With Hybrid/EV Battery Interface Control Module N circuit or function; the stored code identifies the affected component rather than a single failure mode.

Is U0347 generic or manufacturer-specific?

U0347 is a generic OBD-II code: it has the same meaning on every make and model that follows the SAE standard.

Can TuningBot remove U0347 at file level?

Not guaranteed. Powertrain (P) codes can be reliably disabled in the ECU calibration, but body, chassis and network codes depend on the specific control unit and how the fault is implemented - some can be handled, some cannot. Ask for a quote and our engineers will check your file and tell you, free of charge, whether U0347 is removable in your case.

Other file services

Stage 1/2/3 TuningDPF RemovalEGR RemovalAdBlue / SCR RemovalDTC RemovalIMMO OFFSpeed Limiter (Vmax)

Understand the system behind this code: Diagnostic Strategy and DTC Logic

ECU tuningDyno-tested results by model and engine See the results →

← Search the full DTC database