Hours: 07–23 daily
EN
Tune your file

TuningBot DTC Database · v4.37.15

U0320 Software incompatibility - power steering control module

Generic (OBD-II) interpretation in the TuningBot DTC database.

U · NetworkNetworkOBD2

What U0320 means

U0320
Software incompatibility - power steering control module Generic · network Data confidence 78%

The control module detected a fault associated with the Software incompatibility - power steering control module circuit or function; the stored code identifies the affected component rather than a single failure mode.

Symptoms

  • Multiple warning lamps possible
  • Functions of the affected module unavailable

Possible causes

  • CAN bus wiring fault (open, short, chafed harness)
  • Faulty control module loading the bus
  • Connector or terminal corrosion
  • Power supply or ground fault of a module

Recommended checks

  • Perform a full-module scan to map which modules communicate
  • Check CAN bus resistance and voltages at the diagnostic connector
  • Inspect wiring and connectors of the affected module
  • Check module power supply and grounds
  • Disconnect suspect modules one at a time only with a documented procedure

Related and nearby codes

U03 range
U0300U0301U0302U0303U0304U0305U0306U0307U0308U0309U030AU030BU030CU030DU030EU030FU0310U0311

How to read U0320

U

Network: communication between control units.

0

Generic SAE-standard code: same meaning on every make.

320

Specific fault index within the subsystem.

Frequently asked questions about U0320

What does U0320 mean?

Software incompatibility - power steering control module. The control module detected a fault associated with the Software incompatibility - power steering control module circuit or function; the stored code identifies the affected component rather than a single failure mode.

Is U0320 generic or manufacturer-specific?

U0320 is a generic OBD-II code: it has the same meaning on every make and model that follows the SAE standard.

Can TuningBot remove U0320 at file level?

Not guaranteed. Powertrain (P) codes can be reliably disabled in the ECU calibration, but body, chassis and network codes depend on the specific control unit and how the fault is implemented - some can be handled, some cannot. Ask for a quote and our engineers will check your file and tell you, free of charge, whether U0320 is removable in your case.

Other file services

Stage 1/2/3 TuningDPF RemovalEGR RemovalAdBlue / SCR RemovalDTC RemovalIMMO OFFSpeed Limiter (Vmax)

Understand the system behind this code: Diagnostic Strategy and DTC Logic

ECU tuningDyno-tested results by model and engine See the results →

← Search the full DTC database