TuningBot DTC Database · v4.37.15
Generic (OBD-II) interpretation in the TuningBot DTC database.
The control module detected that the signal in the Intermediate Shaft Selection Actuator Position circuit stayed above the expected operating range.
Powertrain: engine, transmission and driveline systems.
Generic SAE-standard code: same meaning on every make.
Specific fault index within the subsystem.
Intermediate Shaft Selection Actuator Position Sensor Circuit High. The control module detected that the signal in the Intermediate Shaft Selection Actuator Position circuit stayed above the expected operating range.
P2E18 is a generic OBD-II code: it has the same meaning on every make and model that follows the SAE standard.
If the fault logic lives in the ECU calibration, yes: our DTC Removal file service disables the specific fault entry. Checksum correction is not included: it is a separate, optional service. Not sure whether your case qualifies? Request a free assessment and our engineers will check your ECU file.
Understand the system behind this code: Diagnostic Strategy and DTC Logic
ItalianoIT
DeutschDE
EspañolES
PortuguêsPT
FrançaisFR
РусскийRU