P2E17 Intermediate Shaft Selection Actuator Position Sensor Circuit Low

Intermediate Shaft Selection Actuator Position Sensor Circuit Low. The control module detected that the signal in the Intermediate Shaft Selection Actuator Position circuit stayed below the expected operating range.

P2E17 is a generic OBD-II code: it has the same meaning on every make and model that follows the SAE standard.

If the fault logic lives in the ECU calibration, yes: our DTC Removal file service disables the specific fault entry and, where the ECU needs it, corrects the checksum too. Not sure whether your case qualifies? Request a free assessment and our engineers will check your ECU file.