TuningBot DTC Database · v4.37.14
Generic (OBD-II) interpretation in the TuningBot DTC database.
The control module determined that the Pressure Control Solenoid F did not change state as commanded and appears stuck.
Powertrain: engine, transmission and driveline systems.
Generic SAE-standard code: same meaning on every make.
Specific fault index within the subsystem.
Pressure Control Solenoid F Stuck On. The control module determined that the Pressure Control Solenoid F did not change state as commanded and appears stuck.
P2733 is a generic OBD-II code: it has the same meaning on every make and model that follows the SAE standard.
If the fault logic lives in the ECU calibration, yes: our DTC Removal file service disables the specific fault entry and, where the ECU needs it, corrects the checksum too. Not sure whether your case qualifies? Request a free assessment and our engineers will check your ECU file.
Understand the system behind this code: Diagnostic Strategy and DTC Logic
ItalianoIT
DeutschDE
EspañolES
PortuguêsPT
FrançaisFR
РусскийRU