Hours: 07–23 daily
EN
Tune your file

TuningBot DTC Database · v4.37.14

P228C Fuel Pressure Regulator 1 Exceeded Control Limits - Pressure Too Low

Generic (OBD-II) interpretation in the TuningBot DTC database.

P · PowertrainFuelOBD2

What P228C means

P228C
Fuel Pressure Regulator 1 Exceeded Control Limits - Pressure Too Low Generic · fuel Data confidence 85%

The control module detected that the monitored Fuel Pressure Regulator 1 value exceeded the calibrated threshold.

Symptoms

  • Possible hard starting or long cranking
  • Possible reduced power or cutting out
  • MIL illuminated

Possible causes

  • Low-pressure fuel supply fault (pump, filter, lines)
  • High-pressure pump wear or fault
  • Pressure regulator / volume control valve fault
  • Fuel pressure sensor fault
  • Internal leakage (injector return flow too high)

Recommended checks

  • Read specified vs actual rail pressure at cranking, idle and load
  • Check low-pressure supply (pressure/volume) first
  • Check control valve/regulator operation
  • Measure injector return flow where applicable
  • Inspect wiring and connectors of pressure components

Related and nearby codes

Related codes
P228AP228BP228DP228EP228F
P22 range
P2200P2201P2202P2203P2204P2205P2206P2207P2208P2209P220AP220BP220CP220DP220EP220FP2210P2211

How to read P228C

P

Powertrain: engine, transmission and driveline systems.

2

Generic SAE-standard code: same meaning on every make.

28C

Specific fault index within the subsystem.

Frequently asked questions about P228C

What does P228C mean?

Fuel Pressure Regulator 1 Exceeded Control Limits - Pressure Too Low. The control module detected that the monitored Fuel Pressure Regulator 1 value exceeded the calibrated threshold.

Is P228C generic or manufacturer-specific?

P228C is a generic OBD-II code: it has the same meaning on every make and model that follows the SAE standard.

Can TuningBot remove P228C at file level?

If the fault logic lives in the ECU calibration, yes: our DTC Removal file service disables the specific fault entry and, where the ECU needs it, corrects the checksum too. Not sure whether your case qualifies? Request a free assessment and our engineers will check your ECU file.

Other file services

Stage 1/2/3 TuningDPF RemovalEGR RemovalAdBlue / SCR RemovalDTC RemovalIMMO OFFSpeed Limiter (Vmax)

Understand the system behind this code: Diagnostic Strategy and DTC Logic

ECU tuningDyno-tested results by model and engine See the results →

← Search the full DTC database