IMRC Control Circuit, Bank 2
Ford · engine
Data confidence94%
Ford documents P2011:01 for its 2024-2025 gasoline-engine OBD monitor strategy as imrc control circuit, bank 2. This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.
Recommended checks
Perform a full module scan
Review freeze-frame and occurrence data
Inspect relevant wiring and connectors
Check power supplies and grounds
Compare commanded and measured values
Check applicable OEM service information
Applies toFord gasoline-engine OBD applications|2024-2025 model years
P2011:72
IMRC stuck open, Bank 2
Ford · engine
Data confidence94%
Ford documents P2011:72 (actuator stuck open) for its 2024-2025 gasoline-engine OBD monitor strategy as imrc stuck open, bank 2. This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.
Recommended checks
Perform a full module scan
Review freeze-frame and occurrence data
Compare commanded and measured values
Check applicable OEM service information
Applies toFord gasoline-engine OBD applications|2024-2025 model years
P2011:73
IMRC stuck closed, Bank 2
Ford · engine
Data confidence94%
Ford documents P2011:73 for its 2024-2025 gasoline-engine OBD monitor strategy as imrc stuck closed, bank 2. This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.
Recommended checks
Perform a full module scan
Review freeze-frame and occurrence data
Compare commanded and measured values
Check applicable OEM service information
Applies toFord gasoline-engine OBD applications|2024-2025 model years
Powertrain: engine, transmission and driveline systems.
2
Generic SAE-standard code: same meaning on every make.
011
Specific fault index within the subsystem.
Frequently asked questions about P2011
What does P2011 mean?
Diagnostic Trouble Code (3 variants). Ford documents P2011:01 for its 2024-2025 gasoline-engine OBD monitor strategy as imrc control circuit, bank 2. This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.
Is P2011 generic or manufacturer-specific?
P2011 exists both as a generic OBD-II code (same meaning on every make) and with 1 manufacturer-specific interpretation(s): Ford. Always read it in the context of your vehicle.
Can TuningBot remove P2011 at file level?
If the fault logic lives in the ECU calibration, yes: our DTC Removal file service disables the specific fault entry. Checksum correction is not included: it is a separate, optional service. Not sure whether your case qualifies? Request a free assessment and our engineers will check your ECU file.
ItalianoIT
DeutschDE
EspañolES
PortuguêsPT
FrançaisFR
РусскийRU