incorrect gear 7 ratio
Ford · transmission
Data confidence94%
Ford documents P076F:00 (no sub type information) for its 2024-2025 gasoline-engine OBD monitor strategy as incorrect gear 7 ratio. This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.
Recommended checks
Perform a full module scan
Review freeze-frame and occurrence data
Compare commanded and measured values
Check applicable OEM service information
Applies toFord gasoline-engine OBD applications|2024-2025 model years
Powertrain: engine, transmission and driveline systems.
0
Generic SAE-standard code: same meaning on every make.
76F
Specific fault index within the subsystem.
Frequently asked questions about P076F
What does P076F mean?
incorrect gear 7 ratio. Ford documents P076F:00 (no sub type information) for its 2024-2025 gasoline-engine OBD monitor strategy as incorrect gear 7 ratio. This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.
Is P076F generic or manufacturer-specific?
P076F exists both as a generic OBD-II code (same meaning on every make) and with 1 manufacturer-specific interpretation(s): Ford. Always read it in the context of your vehicle.
Can TuningBot remove P076F at file level?
If the fault logic lives in the ECU calibration, yes: our DTC Removal file service disables the specific fault entry. Checksum correction is not included: it is a separate, optional service. Not sure whether your case qualifies? Request a free assessment and our engineers will check your ECU file.
ItalianoIT
DeutschDE
EspañolES
PortuguêsPT
FrançaisFR
РусскийRU