Fuel Pump Secondary Circuit Low
Ford · fuel
Data confidence94%
Ford documents P023F:11 (circuit short to ground) for its 2024-2025 gasoline-engine OBD monitor strategy as fuel pump secondary circuit low. This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.
Recommended checks
Perform a full module scan
Review freeze-frame and occurrence data
Inspect relevant wiring and connectors
Check power supplies and grounds
Compare commanded and measured values
Check applicable OEM service information
Applies toFord gasoline-engine OBD applications|2024-2025 model years
P023F:12
Fuel Pump Secondary Circuit High
Ford · fuel
Data confidence94%
Ford documents P023F:12 (circuit short to battery) for its 2024-2025 gasoline-engine OBD monitor strategy as fuel pump secondary circuit high. This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.
Recommended checks
Perform a full module scan
Review freeze-frame and occurrence data
Inspect relevant wiring and connectors
Check power supplies and grounds
Compare commanded and measured values
Check applicable OEM service information
Applies toFord gasoline-engine OBD applications|2024-2025 model years
Powertrain: engine, transmission and driveline systems.
0
Generic SAE-standard code: same meaning on every make.
23F
Specific fault index within the subsystem.
Frequently asked questions about P023F
What does P023F mean?
Diagnostic Trouble Code (2 variants). Ford documents P023F:11 (circuit short to ground) for its 2024-2025 gasoline-engine OBD monitor strategy as fuel pump secondary circuit low. This three-byte interpretation is application-specific and identifies the detected monitor condition rather than a confirmed failed component.
Is P023F generic or manufacturer-specific?
P023F exists both as a generic OBD-II code (same meaning on every make) and with 1 manufacturer-specific interpretation(s): Ford. Always read it in the context of your vehicle.
Can TuningBot remove P023F at file level?
If the fault logic lives in the ECU calibration, yes: our DTC Removal file service disables the specific fault entry. Checksum correction is not included: it is a separate, optional service. Not sure whether your case qualifies? Request a free assessment and our engineers will check your ECU file.
ItalianoIT
DeutschDE
EspañolES
PortuguêsPT
FrançaisFR
РусскийRU